water butt / hydroponic tank hose quick connector
Print Profile(1)
Description
Here is a hose quick connector for a water tank that I designed for re-filling my water butts and hydroponic water tanks. It saves having the hose come out of the tank when re-filling, just mount into the top of the tank above the desired water level or into the lid.
It takes a standard hose connector o-ring measuring I.D. 11mm x 2.5mm section diameter on the connector end and a I.D 31mm x 3.5mm section diameter for the tank connector flat or you could use silicone here.
The connector has been designed to print without supports and work straight from the print bed, there may be one or two strings on the start of the thread of the nut but there is no need to trim these the nut will thread straight on.
Thanks for looking, if you like my work please boost, like, rate or comment. You can check my other models HERE
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (25)