VW ID.4 /Skoda Enyaq iV Camera Hood
Remixed by
Copyright Claim
VW ID.4 /Skoda Enyaq iV Camera Hood
Remixed by
Boost
9
14
12
Print Profile(1)
0.2mm layer, 2 walls, 5% infill
Designer
27 min
1 plate
Open in Bambu Studio
Boost
9
14
12
2
40
42
Released
Description
Does an excellent job of blocking glare from the rear plate to allow night vision to work properly, while still allowing you to see the edge of the bumper when judging position.
Should be a perfect snug fit.
Not heavily modified from the version by harix84, but wanted to expand the reach of this model into MakerWorld with all the settings predefined for anyone else who needs this.
Strongly recommend ASA for this print due to UV resistance required for this exterior accessory. TPU and ABS should hold up fine, but would likely experience discoloration over time.
Comment & Rating (12)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 5% infill
I did two prints of this model. First with your profile, but wasn't happy with the quality. Made some changes and now i gotta say the print quality is extreme. :'D I did however change alot in the profile (filament-settings, print speed, volumetric speed, walls, infill, support etc) so i'm gonna try to up load it here somehow. Thanks!
The designer has replied
1
Reply
I will definitely check out your profile and see what I can learn, thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
I haven’t installed on the car yet.
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
Works great. Thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
Worked very well in PETG
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
printed nicely and fits well. printed in PETG
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
Boosted
Anyone tried this on Enyaq? How do i mount it? Glue, or just press it on? =)
The designer has replied
0
Reply
should just press on like the ID.4
1
Reply
Boosted
Replying to @JakeMakes
Thanks! Will try. I also have another modell i printed last week that i have not tried yet :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
snart
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRemixes (1)
© 2024 MakerWorld