Print Profile(1)
Description
Masculine styled unisex ring. Best printed in TPU but I have printed this ring in TPU, PLA and transparent PET-G. I found it to be more comfortable printed in TPU. I made this design only 2mm thick at its widest part to be comfortable.
Boost Me (for free)
I greatly appreciate your boosts! I never sell my designs or prints and the boosts help with filament!
No supports needed.
I designed this ring to be worn as is or you can do your own thing with the channel.
In the photos you can see I put 5 of these on a cup turner after pulling the cup foam adapter off. I then mixed up really small amounts of resin mixed with micah powders (Pearlex) and filled the channel while the rings were turning on the cup turner to keep it even. After I used a small soft tip to clean up the edges of the ring.
I also done a few with some flat back rhinestones and added resin over the top but I didn't care for the finished look. Was better without the resin.
I was worried about the resin sticking to the tpu- it does adhere well and even when I bent the ring almost flat- it cracked but did not come off. So just know if you bend the tpu ring too much the resin will in fact crack. I believe it will hold up to normal wear just fine!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (40)