CR-X upgrades stabilising rods charger stabiliser

Large format bed slingers suffer from instability and Z wobbling especially at high heights. There are models online of stabilising rods for the CR-X's cousin (CR-10) but there are none for the CR-X - until now! These rods (and triangle braces) also provide a huge amount more stability at lower ranges, allowing for speedier printing.

Additionally, is a plug stabilising as my female plug on the CR-X was wobbly and would often result in a power cut upon the slightest bump.

Hardware required

• 770mm 10mm rods x2
• Nuts for 10mm rods x8
• 3mm screws x4 (about 10mm longer than the stock ones, for the bottom, the stock are not quite long enough)
• 4mm screws x2 (about 10mm longer than the stock ones, for the triangle brace for the sliding Z - axis)
• 5mm screws x4 (about 20mm longer than the stock ones, for the top rod holder)

Hope this helps someone out there.