Search models, users, collections, and posts
IKEA Skadis - Straight hook
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
27 min
1 plate
Open in Bambu Studio
Boost
255
916
72
6
1.6 k
1.1 k
Released
Description
Description
Description This design works with 2 hooks, which is easy to install and remove, but holds very well thanks to the small protrusions on the hooks. This design has been improved at a right angle to accommodate scrapers or wide brushes.
Print instructions
- I used PLA, but any material should do
- No supports needed
- 4+ perimeters for added stiffness
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (72)