Ruleman (bearing) con bolillas de 5mm(3/16) 5mm
Print Profile(0)
Bill of Materials
Description
Ruleman con centro de 5mm , 20mm de espesor y 15mm de alto
lleva bolillas de acero de 3/16 o 5mm si pueden ser delrin o acetal pom mejor
el de la foto es en petg es para bajas revoluciones a menos que lo hagas en acetal POM o nylon 6 , nylon 12 o policarbonato.
en mi caso lo hice con petg podria hacerse con abs pero para usos livianos en ese caso
pueden colocarse por la ranura la bolillas y mantenerse con los aros
no muy apretados y una vez colocados
se mantienen cerrados por las tapas superiores
link de como se arma:https://youtu.be/uLHRHTA7bjE
Bearing with 5mm center, 20mm thick and 15mm high
It takes 3/16 or 5mm steel balls if they can be delrin or acetal pom better
It is for low revs unless you do it in this material or nylon, max nylon 12 or polycarbonate.
in my case I did it with petg it could be done with abs but for light uses in that case
the balls can be placed through the slot and kept with the rings
not too tight and once placed
are held closed by the top caps
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)