Search models, users, collections, and posts
Pixel Watch 2 Travel Charger
Print Profile(2)
Larger Charger Groove
Designer
40 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
40 min
1 plate
Open in Bambu Studio
Boost
38
100
30
6
170
119
Released
Description
Folding travel charger for Pixel Watch 2. Printed without supports on X1 Carbon. May need supports on other machines if bridging isn't as good. for assembly you will need 2 M3x10mm screws. thread them into the hinges and tighten snuggly to allow firm adjustment of charger folding. to insert charger feed the USB C connector through the slot in the bottom of the stand and feed the cable all the way through push the end of the charger into the cutout until seated completely and finally push the cable firmly into cable slot on the bottom. Make sure to allow enough slack in the cable for the stand to fold without tension on the cable.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (30)