Search models, users, collections, and posts
DS2000 Telescope Mount (WIP)
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
5
9
3
1
9
3
Released
Description
Replacement for the DS2000 motor mount.
Work in progress.
My main PCB is dead, so I'm using an arduino which takes inputs from a thumbstick controller I made.
It's not shown in this pic, but I recommend wrapping a thick elastic band around the side post, to give some spring to the main worm gear. Then adjust the pressure with the M3 bolt that sticks out the side.
2025 update - I have now added in the IR encoder.
After printing, cut the red section (see pics), to allow the IR diode bump to slide in.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)