Search models, users, collections, and posts
Fnirsi HS-01 Storage Box / Kaiweets KETS02
IP Report
Print Profile(1)
Variable Layer Height, 3 walls, 4 Top Layers, 15% Support Cubic infill
Designer
7 h
2 plates
Open in Bambu Studio
Boost
136
283
28
19
382
148
Released
Description
My Fnirsi HS-01 Kit came without a storage box.
After briefly looking online, none seemed to fit my complete set including power adapter and several tips.
So, I designed my own.
It should also work for the Kaiweets KETS02
This is case can fit:
- HS-01 Soldering Iron
- 7 Additional Soldering Tips
- USB-C Power Cable
- Small Stand
- EU 65W GaN Power Adapter
- DC Jack Adapter
- Small Roll of Solder
It prints easly, with no supports needed.
Additional Hardware needed:
- 8x1mm Round Magnets
- Some Glue for the magnets
ChangeLog:
V1.1 (2023.10.29)
- Made magnet holes slightly larger
8.1mm for easy fit of magnets, less dependant on tolerances - Enlarged Power Adapter Cut-out for better fit
- Added Retaining Clips on the lid, prevents lid sliding off
- Added Grips to lid for easy removal
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (28)