wsantos

Obrigado, serviu perfeitamente para meu proposito, pena que danifiquei um fan antes de pesquisar, mas vou usar bastante nos outros que vou fazer manutenção. Para mim funcionou melhor com orientação de impressão diferente da original, usei uns suportes ai ficou mais forte.

Thank you, it served my purpose perfectly, too bad I damaged a fan before searching, but I will use it a lot in others that I will do maintenance on. For me it worked better with a different printing orientation than the original, I used some supports and it became stronger

user_3376849936

done, I haven't tested it so let me know if it works.

user_1086594409

Bonjour, serait il possible d'avoir une longueur de bras supplémentaire en 60 ou 70 mm de longueur ?
Merci

Hello, would it be possible to have an additional arm length of 60 or 70 mm Thank you

I've pushed more sizes, let me know if that works for you, hope you like it.

Works wonders just right after the print. If only a couple of arms with different lengths were included!

afmat

Thank you, I hope you like it, I'm planning to make a bigger version too.

BigTone

Yes, I've been using it on my project without a problem the size of the bearing is `8 mm x 22 mm x7 mm` but I will make the arms a little longer later this week.

im curious, did you try if it worked with a bearing that size?


𝓢𝓴𝔀𝓮𝓪𝓴𝓢

Mxz440

0.16mm layer, 2 walls, 15% infill

datasteam

fRAStone

Can you tell me more about it? because I've been using it without any issues, if you can show me where it broke I can try to adjust, ty.

No tiene la robustez suficiente para el trabajo

It lacks sufficient robustness for the task

George

Schabberhannes

cover

IMG_4785.jpeg

arms

plate_1.png

Screws

plate_2.png

base

plate_3.png

puller.png

2024-07-07_0b9473bc91615.png

<ul><li>Keep outer wall speed for precision</li><li>Support is needed but it's effortless to remove</li><li>You can play with walls for more strength but it's already good with this settings&nbsp;</li></ul>&nbsp;

I&#39;ve been doing some prints that needed 608 bearings but was having difficulty removing them.

Print Profile(1)

Description

Comment & Rating (25)

License

Related Models

Bering puller / remover - tree sizes

Print Profile(1)

Description

Comment & Rating (25)

License

Related Models