buckle replacement

Clicks perfectly. I had a 40mm strap, so I scaled up the model without problems. Just missing that a extra loop (strap adjuster attached to it) in the female so the strap gets more tight, right now slides if I pull.

Ok print, did not like support removal... Will try again after adjusting position & supports. thanks

Printed using PETG, workshop and looks good.

brilliant print needed one quick after the one broke on my daughters lanyard printed in petg

funktioniert gut

looks fine, but I don't think it will hold upp for long in PLA. I bit too tight and the female part could be sturdier where the strap goes

was able to scale it and modify the "middle finger" to make it fit my specific use case

Scaled up to about 250% to use as a hip buckle replacement on a backpack. Printed using PLA Tough+ with 6 walls and solid infill to maximize strength. Ironing and orienting the female side of the buckle vertically on the plate helped with neatness issues. The biggest issue is that the female side *will not work* on an adjustable strap. It lacks the extra arm that the male side has in order to create friction with the strap, so it will only work on a strap that has a static loop on the female end or can be sewn shut. Really should update the description to make it clear that this can't be used unless one strap is fixed.