Search models, users, collections, and posts
Wing rc car buggy 1/8
IP Report
Print Profile(4)
0.2mm layer, 3 walls, 15% infill
Designer
1.8 h
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
2.1 h
1 plate
0.12mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
0.28mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
167
266
30
7
468
150
Released
Description
Content has been automatically translated.
A standard replacement rear wing for 1/8 offroad buggies. I divided it into three parts for increased print strength. You just need to glue or solder the side wings into the main wing. A little sanding on the edges of the main wing is necessary to fit the rear wings in place. It's up to you which material is better... maybe polycarbonate could withstand the stresses better? Let me know in the comments
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (30)