Glock 19 V9 - Look Ma No Glue Edition

Remix of: Glock 19 V9 New Slide By: RTX_Nitrox

The goal of this remix is to remove the need for glue.

----------Notes----------

• The photos show gaps between the body and slide. This happened during the print from edges lifting from the bed and is not part of the design. There could be a small gap from the slide core being a tad taller, but I need a clean print to check it. 
• There were problems with the 3D models and needed to be repaired. The repair caused minor alterations to the models. 
• Redesigned slide and body interfaces to assemble with no glue required so you can replace broken parts. 
• Only the modified models are included in the raw model file section. See original listing for remaining raw model files.

----------Instructions----------

1. Install a rubber band in the slide core and attach the other end of the rubber band to the slide rubber band retainer.
2. Insert the rear end of the slide core into the front of the slide housing with the barrel holes matching up sides on the body.
3. Pull the rubber band retainer back for clearance and slide the core back, then push down to seat the slide core.
4. Pull slide core all the way forward.
5. Insert the rubber band retainer into the slide.
6. Release slide core. Caution: The slide core will slide back, keep fingers clear. 
7. Insert the barrel into the slide core.
8. Ensure the slide core interface area on the body is clear of support filament.
9. Wedge the slide core to body interface into the body at the back and pull back the slide.
10. Press the front of the slide down to snap it into the interface at the front.
11. Release slide.
12. Fin.