Search models, users, collections, and posts
HY300 Wall-Mounted Projector Holder
Remixed by
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 13% gyroid infill
Designer
38 min
1 plate
Open in Bambu Studio
Boost
609
1475
122
23
2.8 k
1.8 k
Released
Description
Slide-in design with a bottom shaped to seat the projector and stoppers to prevent it from falling out. The shape of the holder allows for any tilt of the projector. It is mounted using two screws with a diameter of 4mm, either with wall anchors or directly into a beam.
Boost Me (for free)
Boots to support me!
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (122)