Dynamite Clock/Lamp

[Introduction]

Well, what can I say? It's a clock shaped like a bundle of dynamite! This makes use of the clock kit, and optionally, the lamp kit. You can print it solid for a straight forward clock, or print it using transparent petg or glow pla for a little extra fun.

[Hardware & Filament]

Hardware Required:

1 Clock Components Kit 011 (Sold on the Bambu Store)

1 LED Lamp Kit 001 (Optional) (Sold on the Bambu Store)

11 - BT2x8mm Self Tapping Screws (Sold on the Bambu Store)

Featured Filaments:

Bambu PETG-CF Brick Red

Bambu PETG-CF Black

Bambu PLA Metallic Iridium Gold

Bambu PLA Metallic Iron Gray

Polymaker Polyterra Muted White

Bambu PETG Translucent Clear

Bambu PETG Basic Black

Bambu PETG-CF Brick Red

Bambu PLA Glow Pink

Bambu PLA Basic Blue Gray

Bambu PLA Matte Black

Bambu PLA Matte Ivory White

[Assembly]

Step1: Install the 2 bands, and then insert the 6 screws to secure the bands in place.

Step2:

• Install the lamp kit, if you choose to. Route the wire out the back.
• Install the base onto the main body, and insert the 3 screws to secure it in place.

Step3:

• Insert the clock component through the main body of the dynamite sticks. Make sure it's orienated so the dial set is on the top. This will make it easier to access later on when we want to set the time or change the battery.
• Install the two front faces and screw them in place, then install the nut included with the clock kit to secure everything in place.

Step4:

• For the second hand, we want to use the base pin that came with the clock kit. We'll snip the ends off, leaving us just the pin. We'll insert it into our 3d printed second hand
• Install the Hour hand, Minute hand, and Second hand. I recommend installing them at 12:00, and then using the dial to set the time.

Step5: Put the lid on!

-------

If you like my work, consider showing your love by Buying me a coffee. Additionally, if you're looking to sell prints of my design, please check out my Patreon page for more information.