Search models, users, collections, and posts
Flange Bearing Item#: 741-0663
Remixed by
IP Report
Print Profile(2)
PETG - 0.2mm layer, 2 walls, 100% infill
Designer
19 min
1 plate
PC - 0.2mm layer, 2 walls, 100% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
0
5
0
0
6
3
Released
Description
Typically when the wrong shear pins are used in these snow blowers (20-28") the brass gear ends up stripping, or in my case splitting in half and knocking out this busing when that happened
I printed out of PETG-CF as that's what I had on hand. It's surrounded by grease so I'm not worried, but as the original author mentioned; nylon would be best.
Measurements - 0.50" ID, 0.75" bushing OD and 1.00" flange OD with a 0.625" height. Size of bevel adjusted to match original.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)