SWIMBAIT MOLDS Lure Fishing

Have fun throwing the soft lure by printing this mold and pouring your silicone in. Print mold, clamps and cavities on the build plates. May need to sand the tops of the spheres it they did not print perfectly. Place the cavities in the spaces given. Put a little bead of fun-tak or taky putty around the mold to help keep the mold from leaking silicone when pouring. You will may want to grab some vaseline or something else non-stick and put it throughout the mold. Once you have done that close up the mold and use the clamps to hold the mold closed. You could use your own clamps and clamp stands if you do not want to print them. If you are using the big mold mix up about 160 grams of silicone up and slowly pour it the molds. You can use a little piece of filament to help agitate the silicone and get the air tramped at the bottom of the mold if needed. I using the smaller mold I would mix about 40 grams and slowly pour. After a few hours check on your silicone molds and see how the level is and add more if needed to the top of the mold. A different color works perfectly here. After 6 hours you can open up the molds and grab your swimbaits out. A little pair of scissors it perfect to cut off any excess. After that have fun fishing with these little bad boys.

Here is were I bought the supplies on Amazon
Silicone
https://a.co/d/a4jSLrD

Mica
https://a.co/d/17JoLWS

If you like the fishing lure and would like more go to my collection of lures and take a look and don't forget to rate it please.

https://makerworld.com/@Meyerhouse/collections/1636520

Thanks for downloading it and making me want to make more models. Have fun printing

If you would like to support me and sell my models please join my Membership Or join from Patreon here https://www.patreon.com/Meyerhouse?utm_campaign=creatorshare_creator