CO2 sensor enclosure (D1 Mini + SenseAir S8) - Free 3D Print Model

Search models, users, collections, and posts

Citruspers

Hobby & DIY>Electronics

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

H2S

H2D

P2S

A1 mini

X1E

H2D Pro

H2C

X2D

A2L

0.16mm layer, 2 walls, 15% infill

1.1 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Description:

A small enclosure for a Senseair S8 CO2 sensor and a Wemos D1 Mini ESP 8266 board. No supports and no fasteners needed. Everything just slides into place.

Tips:

Make sure the wiring connects from the wifi-side on the D1, and the plastic side on the Senseair, otherwise things may not fit.

I printed this in PLA using a 0.4mm nozzle at .15mm layer height.

.STEP and .f3d files are included, feel free to improve/adapt and share alike!

Software:

I'm using this with Home Assistant using the excellent ESPHome project.

Comment & Rating (5)

@MaxWinterstein

Boosted

Tiiiiight fit, but using some silicon cables i succeeded. thanks!

The designer has replied

@Citruspers

Thanks for the boost! I'll keep the cable-spacing in mind for any future models, I agree it's a bit tight (but doable) :)

@NikoD

Boosted

Perfect print. 10+ mate

The designer has replied

@Citruspers

Glad you like it, and thanks for the boost!

@vbueschken

An ESP32 D1 Mini board typically measures approximately 39 mm x 31.5 mm For comparison, an ESP8266 D1 Mini is slightly smaller (approximately 34.2 mm x 25.6 mm) The case fits the ESP8266 D1 Mini

Show original

No more