Search models, users, collections, and posts
WE Apache Magpul Style Handguard
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 30% infill
Designer
5.1 h
1 plate
Open in Bambu Studio
Boost
33
121
8
2
106
54
Released
Description
Description
A Magpul style handguard for the WE Apache.
Installation
You may need to drill out the front pin holes to 6/6.5mm to get a snug fit. I've drilled the left hole out to 6mm and the other to 6.5mm to get a good tight fit. There is also a tab that can to be screwed in to tighten things up further, should just need a countersunk M3x8mm screw.
Printing
Print in the orientation shown in the screenshot, alternatively you can print from the base straight up.
I have also set a fuzzy skin on mine, I think that .1 point distance and thickness works well. Although I think it would look a lot nicer in a matte filament.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)