LCR-T3 ESR Component Tester Simple Case - Free 3D Print Model

Search models, users, collections, and posts

Tanu

Hobby & DIY>Electronics

IP Report

Print Profile(1)

All

P1S

X1 Carbon

H2D

A1 mini

P1P

P2S

X1E

H2D Pro

H2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

2 h

3 plates

5.0(1)

Open in Bambu Studio

Boost

Released

Description

This is a simple case for LCR-T3 ESR component tester.
Use 4 small self tapping screws to close the enclosure.

Comment & Rating (6)

@user_2005941468

 “My device doesn’t fit — the box is too small.”😭

@norakroto

The print profile is no longer public

@acn123

The print profile is no longer public

Nice design. My T3 tester has a little different PCB dimensions and very bad soldering - socket and screen are crooked and off by 2-3 mm :-). I did fix the PCB with some screws. For the lid 2 mm screws, good fit, although holes are a little close to corners. Socket was off by around 3mm so had to cut lower part of the lid. Would have to remodel an reprint the lid but that's the problem with my board, not the model. What is the connector you soldered between the ZIF socket and power button?

The profile uploader has replied