PeGys

cover

large_display_784b423a-e3da-4419-9449-149afa19d3f1_0183349d-42da-4e9f-8e78-a01eae3075da.jpg

plate_1.png

Serpandrew

blade of chaos 1.jpg

blade of chaos 2.jpg

blade of chaos 3.jpg

slicer.png

2024-08-15_6086094b8cb1

<ul><li>Flipped model to stand on the handle/base, results in clean print with less support (if placed on side you'll have either heaps of support or bad finish)</li><li>Tried a couple prints to get to this and this was the best result</li><li>0.08mm layer height for high quality</li><li>Ironing on top surfaces for smooth finish on flat areas</li><li>15% Gyroid infill</li><li>Infill combination enabled</li></ul>&nbsp;Slow-ish print due to 0.08mm layers but high quality. Just under 5g filament including support.Photos are actual result of this profile.&nbsp;

0.08mm layer, 2 walls, 15% infill - High Quality

Jaatinen3D

Ringchaku Spinning Fidget Toy

Made a blade of chaos remix for this amazing fidget based on the nunchaku model of <a target="_blank" href="https://makerworld.com/en/@Jaatinen3D" rel="nofollow noopener">Jaatinen3D</a>.  It snaps right onto the original chain.

Chaos Blade for Ringchaku Spinning Figet Toy

ASIA

Print Profile(1)

Description

Comment & Rating (35)

This remix is based on

License

Related Models