Search models, users, collections, and posts
Upper glass riser also works with AMS
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
0.2mm layer, 2 walls, 15% infill Cubic - PETG
1.2 h
1 plate
Open in Bambu Studio
Boost
218
605
283
76
1.4 k
1.1 k
Released
Description
Also works with AMS modules for X1C / P2S / P1
The upper glass is raised by 20mm and a ventilation slot is created on all sides. For example, with a PLA print, the heat is vented at the top. Glass plate is also held in place on the spacers with a form-fit. Leave the door half open or so for good ventilation. An additional benefit is that the filament tube no longer touches the glass and therefore no abrasion is produced.
No magnets or support material are needed. Only 47g of filament is needed for the four parts.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (283)