Pill Pods (supplement dispenser) - 2x larger - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

postscarce

Tools>Medical Tools

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer

Designer

16.8 h

4 plates

5.0(48)

Open in Bambu Studio

Boost

220

696

842

486

Released

Description

This is a remix of “Pill Pods (Pillbox / Supplement dispenser)” by SMACKMAX.

The original wasn't big enough for my daily supplement stack, so I remixed the models for larger capacity.

The X, Y, Z dimensions have been increased by 25%, which (if I did my math right, the pods being cylinders) translates to almost 2x the volume – that means twice as many supplements can fit in the pods.

In order to make the dispenser fit in my P1S build volume, I split it using a dovetail slice. I also adjusted the strength and support settings for the pieces, and removed the bottom shell layers from the rectangular container piece to save on filament (because who's going to look at the bottom anyway?).

Comment & Rating (63)

@Blakestr

Super duper frustrating to spend all this filament only to have these two bits break off when trying to connect them. Why are they so fragile? This happened TWICE and it's all the more frustrating because It STILL BROKE despite me being extremely cautious due to the fact of alreadying ruining one. I used the default profile.

@mrhansen7692

silk filament.....what do you expect?

@Blackwhisper

Boosted

Print Profile

0.2mm layer

It turned out beautifully 🥰 and practically

Show original

@user_2411009161

model is broken iv just printed the storage base and the entire bottom is missing no settings were changed

The designer has replied

@user_2411009161

just checked the 3mf file and for this object bottom shell is set to 0mm and 0 layers

@postscarce

@user_2411009161 is correct. I mention this in the description. This was motivated to conserve filament.

@Mitchelljprint

Print Profile

0.2mm layer

very nice

@GoblinUrMom

Print Profile

0.2mm layer

I wish it were wider and held 14 for evening dosage.

@user_1833051114

Print Profile

0.2mm layer

top mount and cans. I attached it to the fridge with tape

Show original

@user_3910804253

I’m trying to figure out whether to print this version or the other one. How many supplements were you trying to fit in resp. which size do you recommend for which amount?

@user_1749762238

bumperino

@bro_codepop

bump

@jojobanks

i actually printed this at 115% instead and it fit my 8 supplements (2 large multis and 6 smaller tablets) comfortably. I found 125% to be a little too large for what I needed