Search models, users, collections, and posts
Infinite Skadis for Side of P1S/X1C
Remixed by
IP Report
GIF
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
8.5 h
3 plates
PETG 0.2mm layer, 6 walls, 25% infill
8.7 h
3 plates
Open in Bambu Studio
Boost
1704
6170
438
221
4.9 k
2.5 k
Released
Description
Updated May 2026 for easier install of connections.
**Important info on putting it together:
- Make sure the connectors have the outside fins point DOWN towards the front of the board when installing.
- Connect two long sides together with the outside middle connection FIRST.
- Put the fins in first then click down to insert the connectors down the center line of the board.
P1/X1 Top Hooks mounts HERE.
Lower standoffs from @AU3D
Filament used: Creality PLA+ in Matte Purple
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (3)
Click to see more
Comment & Rating (438)