Wago 221-2411 Triple Mount

This holder is designed to keep three Wago 221-2411 securely held in place via a snap fit, tightly gripping onto several features of the wagos.

When the wagos are in place, it is still very easy to open and close the levers.

You can just slide in the wagos from the side (see pictures). You should feel some resistance and get a snap sound when fully seated.

To remove any wagos again, i would recommend to put a wire into one end of the wago, closing the lever and then pulling the wire to the side and slightly up. Please note that this can take quite a bit of force. You shouldn't do this too often, as with every pull-out you run the risk of damaging some of the smaller features.

In the pictures you can see, that the Bambu Labs Orange PLA matches the wago color quite nicely.

You can attach this mount via double sided tape. I would recommend 3M VHB.

The base plate measures 37x30 mm.

If anybody needs this mount for other arrangements (e.g. 1x) or with screw holes, just write me a comment!

----------------

Update (2024-06-21): increased wall thickness on the sides

Update (2025-04-17): added slim version with screw holes for triple mount

• Walls are now 1mm instead of 1.5mm resulting in a total width of 28mm for the triple mount, instead of 30mm
• I haven't got the walls to break in normal use yet, but they definitely feel a bit less sturdy! So just decide for yourself if you need the extra space gained by the slim version.
• Spacing to the top is now increased by 0.1mm. If you had issues with the top bulging out on the sides, maybe try the slim version.
• Screw holes fit a 3mm wide counter sunk screw perfectly.