Articulated Jumping Spider Keychain Version

This model has been altered to have a large thick keyring loop so that it can be made into a keychain.  The original also has a butt loop but it is much smaller and thinner. 

Suggested scale for printing is 65%-80%.

I was able to print the model at 50% scale but did notice a spot between the first two legs that slightly stuck.  Printing at this size or smaller may be difficult.  I suggest slowing down your print speed if you attempt to print small. Many people have reported successfully printing this model at 40% scale (see the original posting).

*I printed my models on an Ender 3 V3 SE. Results may differ on Bambu printers.

Suggested settings for BODY:
Support: NO
Brim: YES
First layer slowed to 30mm/s

Suggested settings for EYES:
Support: NO
Brim: NO
All layers slowed to 20-30mm/s (the smaller the scale, the slower you need to go, and make sure bed is squeaky clean!)

*It may not be possible for some printers to print eyes for models below 65% scale.  I suggest only printing the “no-eyes” model for sizes 75% and up, that said. I have uploaded a print profile scaled at 65% for the “no eyes” model for those who would like to attempt it.


This model is 100% my own creation and I give the following permissions:

You can:
Sell printed models (online or locally)
Create remix versions with attribution

Please don't:
Sell the model files
Claim the model as your own
Claim remixes as solely your own