Clasic Karambit with Belt Holster
Print Profile(1)
Description
Clasic Karambit with a complete belt holster for Airsoft/Training use. The blade, handle and holster are divided in half to make it easier to print and to have a better appearance after assembly. Also the knife clip itself to the holster thanks to the round projection on the handle.
Print all the parts with a durable material such as PETG/ABS/ASA and the blade in TPU. Supports are needed to print both halves of the handle.
Assembly:
1.- Glue the two halves of the blade and the back ring. Then place them between the two halves of the handle and glue all together.
2.- Before joining the two halves of the holster, glue two M4 nuts to the inside of each half.
3.- The holster can be attached together with just 5 self tapping 2mmx8mm long screws. Although it gives better results also using glue.
4.- Insert 4 M3 nuts into the belt holder parts of the holster. And join them with 4 M3x8mm screws.
5.- Finally, the belt holder is attached to the holster in the desired position with an M4x5mm screw.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (7)