45ACP Sliding Case - 20 Rounds

45ACP ammo case with sliding lid. Holds 20 rounds. I tried to make the case to use minimal filament with minimal print time.

If the tray doesn't fit snug: Place a drop of superglue on each post and then press the tray onto the posts. Let the glue fully dry and before placing ammo inside, or before sliding the lid on. This is to prevent any superglue residue or “bloom” from getting on your ammo and lid.

When printing the tray that you stick the rounds into you may have to adjust the X-Y hole compensation in your slicer, depending on how well your printer is calibrated.

If lid it too loose/tight when sliding you can scale the Y-Axis up/down by 0.2. If you do this make sure that Uniform Scale is NOT checked and only the lid is selected.