Raspberry Pi 3 Model B and B+ Case - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

Didier

Hobby & DIY>Electronics

IP Report

Print Profile(2)

All

A1 mini

P1P

H2D

P2S

X1 Carbon

P1S

X1E

H2S

H2D Pro

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

1.7 h

1 plate

4.9(244)

0.2mm layer, 2 walls, 15% infill (dual colour)

1.6 h

2 plates

5.0(22)

Open in Bambu Studio

Boost

361

839

301

197

3.6 k

2.7 k

Released

Description

Malolo's screw-less snap fit case Raspberry Pi 3 Model B and B+ Case I have adjusted few things so it fits on one build plate it prints really well and snaps into place well

Case was created by Malolo's

Boost Me (for free)

If you enjoy this model, feel free to boost it

Comment & Rating (301)

@jarppinen

Print Profile

0.2mm layer, 2 walls, 15% infill

Prints good, looks okay and does the job.

(Edited)

@Ghost17_XP

if it's ok and does the job, then why one star? give it at least three.

@jarppinen

Replying to @Ghost17_XP :

I did not know i had given low star rating. Must have been miss click! fixed rating!

(Edited)

@Ghost17_XP

Replying to @jarppinen :

ahh I was confused there, hope that didn's sound annoyed or anything, just wanted to point it out. Thanks man

@LonelyLuni

Boosted

printed great😊

@legomyego

Print Profile

0.2mm layer, 2 walls, 15% infill (dual colour)

it looks really good and is open for all the ports I need.

The profile uploader has replied

@ricardoandrade

Boosted

looks great, thank you!

@Folder_Fanatic

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed great, and snaps on to the 3B+ perfectly!

The profile uploader has replied

@didiere

Nice one !

@H2C_von_DuT

Print Profile

0.2mm layer, 2 walls, 15% infill

passt super danke

@TazMan998

Looks good, fits nicely. I went with a 100% infill (only took 2 more minutes to prints).

@lirex

Print Profile

0.2mm layer, 2 walls, 15% infill

It fits very well, the two parts click properly and hold tight, sleek design! Thank you!

@ThaMonkeyClaw

Boosted

Excellent print, fits my Raspberry Pi perfectly! I feel like the posts that the board sits in could have been a smidge longer, but still holds together very well!

@user_2461419813

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed beautifully in PETG HF with the standard profile. I’m really impressed with this design. Clearances were spot on.

@Cheesehead_Dave

Boosted

Old case was being held together by a cable tie so it was time for an upgrade. Printed in black PETG; the Pi fit in nicely and it snapped together perfectly!