Search models, users, collections, and posts
Flag for Step2 KidAlert Sign
IP Report
Print Profile(1)
Step2 KidAlert Flag - 0.2mm layer, 2 walls, 15% infill
Designer
42 min
1 plate
Open in Bambu Studio
Boost
11
18
1
2
22
26
Released
Description
Replacement flag for the Step2 KidAlert street safety sign. Our original vinyl flag was torn off at some point and needed a new one. This was designed to fit over the roughly 6.3mm fiberglass pole, but should fit other similarly sized rods.
I have printed the flag in PLA, but do not know how well it will hold up sitting above pavement in the summer. It's an easy print, so I will just reprint in PETG, ABS or similar if needed.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)