Search models, users, collections, and posts
Palestine Flag - Standing / Waving
IP Report
Print Profile(1)
0.24mm layer, 5 walls, 10% infill
Designer
6.3 h
1 plate
Open in Bambu Studio
Boost
83
36
6
7
43
13
Released
Description
Standing Palestinian flag, requires AMS. Stands on its own.
Did not require a brim to print but if you are not using an adhesive agent or have any question about your adhesion, it might be needed in some cases as each printer / settings / setup is different.
Takes a bit to print as you need two color switches for nearly every layer. You are not putting down a lot of filament at each layer so make sure you have a lot of flushing for that white value otherwise it will end up very pink due to the red-to-white being one of the harder color switches.
Created with Fusion360
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (6)