Anatomical Fencing Grip Voronoi (for Epee / Foil)

If you enjoyed this model, remember to like, follow, and support my work with a nice 

If you're interested in using my models, several membership plans are available, even if you just want to buy me a coffee to show appreciation for my work :D

If you have any requests, don't hesitate to ask in the comments or personal messages!

For anything, don't hesitate to contact me; every request will be fulfilled promptly!

This is a typical grip used in fencing for foil and epee, made cooler by the voroid effect :P
 

It's obviously ONLY for decoration, if printed in plastic (too much strenght and pressure on the grip to be used as a metal one). I suggest to use supports but i STRONGLY raccomend not to use tree-support, due to some difficulties for the “cleaning” part.

100% infill is the best for the best result.

Enjoy!

Every model is PIP; the wheels are actually working.

I used AMS to achieve optimal multicolor results.

The model requires no assembly; you just need to carefully remove the tree supports already set in the print profile.

Better results can be achieved using the 0.2 mm printhead, at the expense of increased print times.

It's recommended NOT to change the print profile settings to avoid having problems with the final result.

I invite you to use tweezers and small pliers to remove the supports.

In more recent models, I've used smaller tolerances for the wheel alignment, to ensure a higher level of detail and fewer supports to remove in that area.

For this reason, it's necessary to "break in" the car once the supports have been removed (trying a couple of times) :D