Mini X-Wing Boomerang

Introducing the mini X-wing boomerang! This is the second piece in my mini boomerang series. Simply print it out, bend at the folds, and throw.

Prints in 15 minutes

No support

less than 9 grams of filament

Works great!

Instructions:

Remove from the buildplate once completely cool.

Turn the boomerang so that the diagonal blade seams are face down, and bend all four slightly up.

Flip over the boomerang so that the other seams closer to the center are facing down, and bend them all slightly up.

Hold the boomerang vertically in your dominant hand in between your thumb and index finger, on the side that the blades curve towards you.

Release with a flick of the wrist, and try to catch it!

Note: It will probably take a little while to get used to the technique.