Search models, users, collections, and posts
CS2 Skeleton Knife
IP Report
Print Profile(2)
0.08mm layer, 4 walls, 40% infill
Designer
2.5 h
1 plate
0.08mm layer, 4 walls, 40% infill
3.6 h
1 plate
Open in Bambu Studio
Boost
850
1752
79
14
2.5 k
1 k
Released
Description
Replica of Counter-Strike 2 ★ Skeleton Knife
250 mm long (Just under 10")
For best results, print either vertically with support, or print the two halves of the blade separately, preferably with low layer height, and then glue them together. To achieve the dual-colour effect shown in the pictures, print the two halves horizontally with a filament change at or near the top layer.
It is possible to print the knife on the A1 mini if you place it diagonally on the bed.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (79)