Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
9 min
1 plate
Open in Bambu Studio
Boost
29
63
0
2
187
50
Released
Description
Replacement/upgrade for the cap on of the TrackPoint (low profile & ultra low profile). It mimics the soft rim design used in Dell Latitude or old IBM/Lenovo Thinkpad.
The cap itself was made for a Lenovo Thinkpad Yoga 12 which uses a low profile TrackPoint Cap. This should match with ThinkPads from approx. 2015. I still recommend checking comparability before printing in the ThinkPad wiki. Attached is also a ultra low profile version for newer devices.
For best results use a 0.2 mm nozzle and low layer height. It should also print with a 0.4 mm but some details might get lost.
Ideally, the material is flexible. The one used for this print is rated at shore hardness 45D.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)