paper towel holder

Thanks for saving me a bunch of time in CAD 😂

I only checked the width, not the length, before printing so I do wish I'd printed a longer center rod, but even so it works quite well and probably doesn't need the extra grip (we'll see when it gets lighter).

Hello. The model is generally good, printed without problems. I reduced the lower platform to fit the larger diameter of the towel and got an ellipse from the main axis seat, so in my case I removed it, and super glue and an extra thread of filament did their job, so everything is fine. Thank you.

Nice clean, functional print. Fits perfectly in the space I need it.

Printed this thinking it would hold my couled air compressor hose. It does, albeit a little too short. Works nonetheless. Great job!

SO impressed with this! Fits the Kirkland brand beautifully. It worked well horizontally, too but with my kitchen setup, vertically worked best. Used double sided tape instead of screws. It’s been over a week since I printed this and zero concerns.

bit short but thats my fault for not checking. doesnt really matter it works well enough.

love it

works great!not too big or too small

smiple fix to smile problem. love it. now my paper towels aren't just setting on the counter.