CR10S Pro VORON Stealthburner Adapter

An adapter for installing VORON Stealthburner toolhead on your Creality CR10S-Pro (if V2 shares the same X-carriage plate, then it works for V2 as well).

Just use this adapter to connect stock X-carriage plate and the SB assembly. The adapter is designed for using LJ12A3-4-Z/BX as ABL (or any other M12 cylinder sensor).

Some M3 screws will be used. If you are assembling a VORON SB toolhead then you should have plenty of spares for them.

After installation, you need to set probe offset X29, using G-code as following:

M851 X29

M500

Offset your nozzle Y-28 by adding a line in printer's starting G-code right after G28 and G29 lines:

G28 X0 Y0 ;Home

G29 ;Auto bed Level

G92 Y-29 E0 ;Reset Extruder

Of course you can also do both offsets in the firmware configuration.

Print guide:

Lay down to the print bed, no support needed