Search models, users, collections, and posts
Original Creality Ender 3 v3 side spool holder
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 5 walls, 15% infill PETG
1.8 h
1 plate
A1 0.2mm layer, 5 walls, 15% infill PETG
2.4 h
1 plate
Open in Bambu Studio
Boost
86
105
10
6
598
76
Released
Description
I have seen a Creality wiki page for a side spool mount. Creality published this upgraded design because the original spool holder is touching the wire harness. Not every one know about the Creality wiki page and that's why I uploaded this file.
Down side: side usb port is almost covered.
It is not my creation. Creality is the designer → https://wiki.creality.com/en/ender-series/ender-3-v3-plus/quick-start-guide/printing-and-installation-guide-for-the-material-rack
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)