Search models, users, collections, and posts
Motley Crue
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
4.3 h
1 plate
Open in Bambu Studio
Boost
13
20
0
0
19
5
Released
Description
Hope you like it.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 159.28x171.98mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm
Filaments Used:
PLA+ Generic black
PLA+ Generic grey
PLA+ Generic purple
PLA+ Generic red
PLA+ Generic orange
PLA+ Generic yellow
PLA+ Generic White
Swap Instructions:
Start with black
At layer #10 (0.88mm) swap to grey
At layer #13 (1.12mm) swap to purple
At layer #14 (1.2mm) swap to red
At layer #17 (1.44mm) swap to orange
At layer #19 (1.6mm) swap to yellow
At layer #20 (1.68mm) swap to White for the rest.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)