Search models, users, collections, and posts
SUNLU pla+ and silk Bambu Lab AMS Spool Adapter Ring
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.5 h
2 plates
Open in Bambu Studio
Boost
48
132
8
8
246
402
Released
Description
Description:
- I've tested these adapters on Sunlu PLA+ and Sunlu Silk
Instructions:
- Print two plates for each a single spool.
- Wide spool ring adapter should be on the right-hand side of the Sunlu spool if you're facing the AMS as you can see on image.
- See attached photos.
Printing:
- Printed with Sunlu PLA +
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)