Search models, users, collections, and posts
Skadis Swiss Tools PB 212.LH-10 RB Inbus set mount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% Gyroid infill
55 min
1 plate
Open in Bambu Studio
Boost
30
94
5
8
183
108
Released
Description
Print upright with standard settings (2 perimeters, 15% infill).
Support for hooks needed. To avoid waste of filament I recommend setting the minimum angle for support to 20 degree. Support only on bed.
The type of filament is up to you. I can't see any limitation using something different to PETG.
BGCODE and 3MF files attached for convenience and reference.
The fitting is tight.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (5)