Search models, users, collections, and posts
one fan for all P1 Hotends with Duct
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 4 walls, 15% infill
Designer
22 min
1 plate
0.6mm nozzle, 0.25mm layer, 4 walls, 15% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
46
148
16
6
120
68
Released
Description
Remixed from 2 Models. I Combined both Models to get the best of them.
Now the Hotend-Fan sucks “cooler” Air from outside the Printhead and the Fan stays in Place when the Hotend is changed. It should provide better cooling to the Heatbreak (so is the Plan).
You have to bite away a bit of the Edge of the Fan.
Printed with 0.6 Nozzle and 0.25 Layerhight
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)