Search models, users, collections, and posts
Foot Massage Roller
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill AMS or NO AMS
Designer
4.1 h
1 plate
Open in Bambu Studio
Boost
29
99
2
4
71
29
Released
Description
Content has been automatically translated.
Two M3 bolts with a length greater than 10mm are required for assembly, as shown below:
Note: Printing without supports and enabling overhang speed reduction can make the protruding parts smoother and less likely to harm the skin. It is recommended to sand the finished product. Normal strength mode is sufficient, and 502 glue can be used to reinforce the rollers on both sides to prevent them from sliding out.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)