Search models, users, collections, and posts
F-15 EAGLE Fighter Jet - NO SUPPORTS
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill, No supports
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
14
18
4
1
33
5
Released
Description
The F-15 Strike Eagle Fighter Jet. Fast and easy print. NO SUPPORTS NEEDED. Takes about 1h 30m to print at normal scale.
IMPORTANT - In order to connect the cockpit to the body some support material must be removed. The tolerances should hold the model together but glue may be needed in some cases.
Settings:
Layer Height - 0.2mm
Infill - 15%
Walls - 3
Supports - No
Raft - No
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (4)