Search models, users, collections, and posts
DJI Osmo Pocket 3 stand
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
27 min
1 plate
PETG Version
43 min
1 plate
Open in Bambu Studio
Boost
294
841
93
35
1.8 k
1.2 k
Released
Description
Content has been automatically translated.
DJI Osmo Pocket 3 stand
- Adjust the height so that it can be placed vertically on the desktop with the official protective case.
- Add threaded holes to the bottom, even though it is plastic.
- This way you can directly mount a mini tripod without needing to add an official extension handle.
- You can also purchase hardware yourself and use a soldering iron to heat up the hardware and melt it in for added strength.
It is recommended to use only on a desktop, not handheld, as the camera may fall out from inside.
I am not responsible for any damage caused by the camera falling off.
- Adjust the height so that it can be placed vertically on the desktop with the official protective case.
- Add threaded holes to the bottom, even though it is plastic.
- This way you can directly mount a mini tripod without needing to add an official extension handle.
- You can also purchase hardware yourself and use a soldering iron to heat up the hardware and melt it in for added strength.
It is recommended to use only on a desktop, not handheld, as the camera may fall out from inside.
I am not responsible for any damage caused by the camera falling off.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Public Domain
Comment & Rating (93)