Search models, users, collections, and posts
New Haven Railroad Coasters
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
5
13
0
0
2
2
Released
Description
New York, New Haven & Hartford Railroad Coasters
These coasters are 89mm square and 3mm thick.
The print profile worked ok for me on my X1C but you might find some settings that are better than what I used.
I always apply a self-adhesive cork backing to my coasters. I have listed a link to them on Amazon. You will most likely have to trim them slightly. https://a.co/d/0PjaF1i
If you like railroad coasters, take a look at my other railroad coasters and clocks at https://makerworld.com/en/@railimages
I would appreciate it if you could rate my print profile and maybe even give it a BOOST, Thanks and enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)