Brass: Birmingham Inserts - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

Jerald

Toys & Games>Board Games

IP Report

Print Profile(4)

All

P1P

X1 Carbon

H2D

X1E

P1S

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 8% infill

Designer

12.9 h

6 plates

4.9(20)

One Color - 0.2mm layer, 2 walls, 8% infill

Designer

12 h

2 plates

4.8(17)

0.24mm layer, 2 walls, 15% infill, Single Color

13 h

4 plates

4.9(10)

New Layout with Redesigned Card Holder

11.7 h

4 plates

4.8(4)

Open in Bambu Studio

Boost

101

287

652

383

Released

Description

Created colourized profile of model

Update: Based on feedback I have turned off ironing on these prints as it seems to be causing some print issues.

Update:

I created a completely redesigned model that allows for vertical storage and each tray is covered.

https://makerworld.com/en/models/1670544

Membership

Commercial Licenses Now Available. Also basic tier if you just wish to add some financial support to help new models come out.

Join

brass

brass birmingham

Comment & Rating (75)

@ClicksMcGee

Boosted

Great print, all the pieces fit nicely! not the best finish on the last layer of the plate with the spacer pieces but otherwise this is perfect!

The designer has replied

@Jerald

Hmm. Were you using Bambu filament? Looks like an issue with the ironing. I can upload a profile without.

@ClicksMcGee

Boosted

Replying to @Jerald :

I used sunlu pla for the black. I saw another poster with a similar result on the spacer as well. I may try a reprint without ironing and see how it goes! EDIT: after loading the file again, it seems like there is no ironing applied by default. Perhaps turning that on for the 4th plate would do the trick.

(Edited)

@mpuffe

Great insert, thanks! :)

The designer has replied

@Jerald

Well done with the use of color.

@gorantse

Good print and design overall.

@canuc

Boosted

Print Profile

0.2mm layer, 2 walls, 8% infill

looks good, perfectly fit.

(Edited)

@arkanederian

Boosted

Print Profile

0.2mm layer, 2 walls, 8% infill

Great design that reduce a lot the setup time. I have split the money holder in two, that's more practical for me.

@phyr3xia

Print Profile

0.2mm layer, 2 walls, 8% infill

Very nice design! Unfortunately, the spacer didn't quite fit for me, I had to make it 2mm narrower, after that it fit wonderfully. I also adjusted the height of the spacers so they are flush with the rest :) Thank you very much! A bonus is that you can place the box upright on the shelf without anything falling out, I love it :)

(Edited)

Show original

@thomrf

Boosted

Print Profile

0.24mm layer, 2 walls, 15% infill, Single Color

worked out great

@user_2369154133

Boosted

Almost perfect. Elegant and the impression was fine. The little flow for me is that sleeved cards get a little higher than the height by 2 or 3 cards as you can see on photos.