Search models, users, collections, and posts
Sunlu S1 Dryer Mount for AMS Riser V2
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
5.1 h
1 plate
Open in Bambu Studio
Boost
128
419
44
36
466
220
Released
Description
Here's a remix of the mount for those who are using the AMS Riser V2 (https://makerworld.com/en/models/133452?from=search#profileId-155321).
I had two dryers from before and didn't want to spend more money on buying the next gen sunlu dryers.
Supports are not needed and all I used was the outer brim to make sure the connector clips did not fall over during the print… because that definitely did not happen to me at all.
You can mirror on the Y-axis if you'd like to have the mount on the other side of the AMS riser and it will work perfectly fine.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (44)