Search models, users, collections, and posts
Canakit Raspberry Pi case and camera mount
IP Report
Print Profile(1)
0.25mm layer, 2 walls, 30% infill
1.7 h
1 plate
Open in Bambu Studio
Boost
1
8
0
0
15
4
Released
Description
This is a case and camera holder for the Canakit Rasperry Pi 2 case. I needed a case that would clip onto my Lowe's shelf support 25.5mm tube so I could use it monitor my 3d printer.
I have also included the file without the support arms, so you can make a freestanding case.
Pretty self explanatory usage and assembly. You will need two M3 socket head screw, two M3 washers, and two M3 locknuts.
The camera case back is a snap fit. Also make sure it is oriented correctly to allow room for the cable to exit. The case pictured uses a Waveshare Pi camera, but I think a regular Raspberry Pi camera will fit as well.
Print Settings
Printer Brand:
MakerGear
Printer:
M2
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.25mm layers
Infill:
30%
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)