Search models, users, collections, and posts
Filament Sample Box 30 slot hinged print-in-place
Remixed by
IP Report
Print Profile(1)
PLA 0.2mm layer, 6 walls, 25% infill
Designer
6.3 h
1 plate
Open in Bambu Studio
Boost
6
15
0
0
15
1
Released
Description
This is the print-in-place 30-card sample box that I've been using.
The print profile has a pause to insert four magnets. Make sure to pay attention to the polarity of the magnets so they will stick together when closed.
The magnet opening is 8x4mm in size. The original instructions say to glue 6x3mm magnets. I'm sure this is fine. I have 8x2mm magnets on hand so I put two in each spot.
Boost Me (for free)
If you're feeling generous and like what you see, Buy Me a Coffee or Send me a tip.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)